Mini processing bowl and small universal ‘s’ blade
Processing small amount of vegetables, herbs, fish or meat use the
mini processing bowl and the small universal ‘s’ blade.
Act according to the instructions ´Operating with the normal processing
bowl` including point 3. Take the mini processing bowl and place it
above the spindle inside the processing bowl (picture A).
Fit the universal S' blade onto the spindle (picture B).
Note: You can use the small universal ‘s’ blade only
when processing inside the mini processing bowl.
The big universal ‘s’ blade as well as the discs do not fit
into the mini processing bowl.
ATTENTION: Use caution, as blades are sharp. Always
handle the processing blade by its central plastic section.
Fit the universal 's' blade over the spindle and press firmly into place.
Ensure the blade is securely locked on the spindle. The blade is correct assembled if the
central plastic section faces upwards and flushes with the wider part of the spindle. Only
the little metal centre of the spindle protrudes about 7 mm. The blade is placed a few
millimetres above the bottom of the mini processing bowl. Proceed with step 5 of the
instructions ´Operating with the normal processing bowl`. Note: The mini processing
bowl has a lid for storing the processed food. Ensure to take the blade out of the mini
processing bowl before closing the lid and storing the food inside the bowl.
Operating with the processing bowl with chute
After processing the food is guided by the ejector disc into the food
collector. Act according to the instructions ´Operating with the normal
processing bowl` including point 2. The chute should be facing the
left side (picture A).
3. Fit the spindle onto the drive shaft, in the middle of the processing
bowl (picture B). The long shaft of the disc stem has to slide over
the drive shaft and the end with the aglet should face upright.
If necessary turn the spindle a little to fit in position. The spindle
sticks out of the bowl for 1 or 2 cm.
Note: All attachments must be firmly attached to the
spindle. Always adjust the attachments until you are
sure that they are correctly fitted.
4. Put the ejector disc on top of the spindle turning the disc until the hexagonal nut of the disc
fits on the hexagon bolt of the spindle. The side with the long central plastic selection has to
face downward and the side with the dents has to face upwards.
Note: The dents on the ejector disc will transport the processed food into the food collector.
12
A
A
B
C
B
40965_designfoodprozessoradvanced_manual_english.qxp 29.01.2008 12:17 Seite 12
(36 Seiten)
(44 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern