Gastroback 41409 Bedienungsanleitung PDF herunterladen (Seite 14)

The motor stops running while operating. The overload protection might got activated. Turn the appliance off

immediately and operate according to the instructions ´Clear a blocking`.

After cleaning the motor does not get started • Is the power cord plugged in?

again when turning the appliance ON. • The motor might be blocked with some hard substance (for example

a bone). Turn the appliance off immediately and pull the plug.

• Disassemble and clean the appliance. Operate according to the

instructions ´Care and cleaning`.

• If the problem is not solved after the cleaning, take the appliance

for technical maintenance and repair to an authorised specialised

reparation shop.

The mincer blocks up permanently • To ensure that the mincer does not seize, never operate it under

while operating. excessive pressure. Operate in a slow and constant pace. Do not

try to rush the procedure by pushing down the meat with force.

• For mincing hard ingredients really fine start with the grinding disc

with the bigger holes. Mincing the second time use the finer grinding disc.

The worm housing moves while operating The closing ring loosened. Turn the appliance off immediately. Assemble

the worm housing according to the instructions ´Assemble for mincing`.

The mince leaks out at the side of the The closing ring is not screwed on tight enough. Turn the appliance off

closing ring. immediately and then pull the plug. Tighten the closing ring but do not

overwind the winding. If the problem still occurs disassemble and clean the

appliance.

Clear a blocking

If the worm housing is blocked no mince comes out of the mincer while operating or the

motor stops moving automatically because of the overload protection.

ATTENTION: If a blocking occurs turn off the appliance immediately. Clear the

problem before turning on the motor again.

1. Turn the appliance off and take the pusher out of the feed chute.

2. If the motor stopped running because of overloading, turn the appliance off and

wait few minutes to allow the motor to cool down.

3. Turn the control switch to reverse and let the motor run in reverse mode for a few

seconds. The worm will turn backwards and loosen the blockage. The appliance will

only run in reverse mode as long as you hold on to the control switch.

ATTENTION: If the motor does not start moving backwards immediately turn

off the appliance and pull the plug. Disassemble and clean the appliance.

4. After a few seconds in reverse mode turn the appliance off and wait a few seconds

for the motor to stop running completely. Turn the control switch to ON. If the

appliance still does not run smooth or the blockage occurs again, turn the appliance

41409_DesignFleischwolfAdvanced_Manual_GermanEnglisch3.qxp 02.06.2009 15:30 Seite 31

1 2 ... 9 10 11 12 13 14 15

Keine Kommentare

Gastroback 41409 Bedienungsanleitung Seite 14